Assembly Instructions

Our metal legs are designed to be detachable. You may use the stainless steel screws in the package to combine the joint pieces with the table legs.

Place your tabletop drill on the ground, flat side up. You can try to put the table legs on the table to test the right position. Mark the positioning of the legs with a tape measure (or a ruler) so that they are evenly spaced on each side.

After you've determined where you want your legs to go, use a 7/16 inches drill bit for pilot holes. Also, you can measure 1'' on the drill bit and then mark it with a piece of tape. This can make sure you do not go too deep.

All products will include the threaded wood inserts, wood strews and spacers. After using the drill bit, you can put the inserts into the tabletop by screwing them in.

Now you can align the table leg with the threaded wood inserts. Then, you can use tools to put the screws into the threaded wood inserts.

Turn the table upside down and you can start enjoying your one of a kind table!